AlternativeManufacturing 'Stubby' Cobb Accessport V3 Vent Dock Mount for 2015+ S

Description

This is a variation of our very popular Accessport Vent Mount that is sleeker and lower cost without sacrificing functionality. If you prefer the added support of the extended backing and magnet, we have another mount listed in our store, but in our testing it’s not needed. With this mount, you will be able to comfortably see your Accessport as you drive along those windy roads. The ODB-II cord is fed under the mount and is held in with a perfect mechanical fit. This kit does not require you to drill or cut anything in your vehicle and it will give you enough room to use the thick OEM Subaru sunshade or other sunshades.
Customer Install Video:
https://www.youtube.com/watch?v=n2NJSxzS-2g
Thanks to Luis (CWP Scoobie) for the install video.
Installation Steps:
Carefully pry up defroster vent on the left side of the dash and remove.
Feed Accessport cable from the OBD-II connector and have it come out of the opening where the vent was.
Remove the pre-installed cable clamp from the mount. Most likely you will use this clamp but if you have the older Accessport cable with the “arrow” sticker then you will use the other supplied clamp.
Feed Accessport cable through the mount and install included cable clamp over the end to secure the cable. (Note: Cable clamp can only be installed one way. Cable should be facing the front and the cable clamp should be on the back of the cable.)
Press cable clamp into mount to lock into position. This will be tight and you will want to push on both sides until the clamp sits flush when it’s fully installed. Be careful to not apply force to the back of the mount where the round metal plate is.
Tilt mount to insert the left corner first and then wiggle it into place on the right side.
Tighten the M3 bolts to secure mount. This doesn’t need to be very tight, just enough that the mount won’t move.
Insert Accessport and enjoy!
Note: If you would like to remove the mount ever, use caution not to fully unscrew the bolts so that the nuts and bracket don’t fall off.
This mount will work for 2015+ WRX/STI